Normally in this fishing technique most fishermen from a boat.
Often they used as floats balloons used in birthdays. But it is a bit cumbersome each time you pull the rod to swell water balloon and tie it to the line and to remove the poke cane, remove the knot of the line and there are times you just click and bait sinks to the bottom and we have thought for a way to avoid these problems.
The issue is to mount floats and fishing corcheo but the problem is we have not found very large floats in the market and those found are expensive.
We propose a simple float fabricaros so with a few euros solve this problem.
Starting a few easy to find materials such as a float for those used to learn to swim in the pools, compressed air hose 6 mm and glue the we can build.
We take the float and will cut into pieces of 25 cm. 30 cm. the size of the lead depends we will use.
Once cut will make a hole in the middle along the piece that we have cut, in my case I used a tip of a broken reed he had and gave me the measure of the pipe installation of compressed air, then we pass the tube inside the hole that we had done and what we will stick to it move not. The glue used to attach the plastic tube is melt silicone used to glue the ring toe.
Then to stop the float in the line use a normal pen or any suit buoy we measure the inner plastic tube.
In the bottom photo shows the finished and ready for fishing float. Below we see another float which we have given shape using a grinder and a disc of multilijas of those used to polish stainless steel.
I hope this article will serve some useful and will continue to give more ideas.
0 comments:
Post a Comment